Yanmar 6CXM-GTE2 Service Manual download pdf (Page 94)

- 3-43-6 -

23) Align the groove of the spring shoe with the setting

bolt and carefully insert the plunger barrel assembly

in the pump housing bore.

24) Install the original shims as marked during disassem-

bly between the barrel and pump housing.

25) Install the delivery valve seat, valve, spring, stopper

and O-ring, then finger tighten the delivery valve

holder.

26) Align the marks on the barrel support and the pump

housing, then tighten the nuts to the specified torque.

27) Tighten the delivery valve holders to the specified

torque.

Note:

Apply clean lube oil to the O-rings and pump

housing bore in order not to damage the O-ring.

Do not try to drive in the barrel.

Before inserting the plunger barrel assembly,

turn the camshaft and set the cam to the position

that the tappet comes to the lowest position.

Torque

39 㨪 49 N࡮m (4 㨪 5 kgf࡮m)

Torque

98 㨪 118 N࡮m (10 㨪 12 kgf࡮m)

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 131 132

No comments

Yanmar 6CXM-GTE2 Service Manual Page 94