Yanmar 4JH3-TCE Specifications download pdf (Page 25)

6. Periodic Inspections and Maintenance

25

EN

6.2.1.7 By using Yanmar Hand

Pump

First follow steps (3) and (4) on page 24.

(1) Connect the hoses as shown above

at the top adapter joint to the hand

pump by using the rubber hose.

(2) Take out the plug from the upper

case cover.

(3) Fill in the oil moved by the hand

pump. Be aware that oil has to flow

down through narrow parts and

then up again. Therefore, during

this procedure, at first suction

pressure will be high and pumping

will be hard. A few minutes waiting

in between will help. The hand

pump (p/#: 28210-000080) and rub-

ber hose (p/#: 196440-92970) are

available from Yanmar, and are op-

tional parts for SD50/-4T. Or any

type of hand pump or rubber hose

(Inner diameter ø14-16 mm) avail-

able from the hardware shop, are

usable.

(4) After filling, first screw in and tight-

en the plug at the top cover. Then

remove the hand pump, hose and

adapter joint and screw in the oil

plug (don't forget the gasket).

6.2.1.8 By not using pump

For the oil filling procedure by not using

pump, see the explanation on chapter 4.,

page 10.

APlug

A

003456-00E

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments