Yanmar 4JH3-TCE Specifications download pdf (Page 26)

26

6. Periodic Inspections and Maintenance

EN

6.2.2 When the boat is out of the

water

6.2.2.1 Preparing the sail-drive:

(1) Remove the bottom drain plug

(2) Screw in the adapter joint (P/N

196311- 92960) with the O-ring (P/N

24311- 000100).

When using own adapter joint, max.

length of thread is 12 mm.

(3) Attach a stiff rubber hose with inner

diameter ø14~16 mm with hose

clips to the adapter joint at the oil

drain position. The hose must be

long enough to drain to bucket.

(4) Take out the dipstick and oil inlet

plug from the upper case cover.

6.2.2.2 Removing oil (total quantity

2.2 liter)

6.2.2.3 By draining

First follow steps (1), (2), (3), (4) on page

26.

Oil drain is possible from this point but will

take much time.

(1) After approx. 0.6 liter has been

drained, remove the oil changing

plug. If you remove sooner, oil may

spill out of this position (because

max. oil level is higher than this po-

sition).

6.2.2.4 Fastest way: Blowing out by

using Air pressure

First follow steps (1), (2), (3) on page 22,

then follow the procedures on page 22. Be

aware that oil is divided in two channels

connected by the lower gear and lower

drain port.

APlug

003457-00E

A

A Tread M10 x 1.5

B Oil changing plug

003458-00E

B

A

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33

Comments to this Manuals

No comments